PHM0C3A049

3AAA / 190lm / 8.5h


Intelligent Infrared Sensor LED Headlight, Hands-free Operation


Available in 2 colours
  • Free Projection Angle
  • Red Rear Light
2 Colours Available
  • Wave Hand for ON / OFF
  • 3 brightness levels
  • Luxeon T White LED - Up to 190 Lumens
  • 2 Operation Methods - Manual Operation or IR Sensor Operation
  • Intelligent IR Sensor for Luxeon LED allows Remote Control when Hands are Dirty or Wearing Glove, like Fishing or Climbing
  • 3 Brightness Levels for Luxeon LED - HIGH, MED & LOW
  • Red LED Indicator shows Stand-by Status of IR Sensor Operation Mode
  • Additional Ø3mm Nichia White LEDs for Close Vision; SOS-Flashing for Emergency Use
  • Red Rear Light on Battery Pack for Safety Indication
  • Water Resistant
  • Operation

    Headlight
    MANUAL OPERATION
    Press the Operation Button to cycle through lighting modes as follow.
    LUXEON SENSOR MODE > LUXEON HIGH > LUXEON MED > LUXEON LOW > 3mm LEDs ON > 3mm LEDs SOS-FLASHING > OFF
    [Press OFF if stays at any mode over 3 seconds]
    LUXEON LED IR SENSOR OPERATION*
    Red LED Indicator will light up to indicate the stand-by status of IR Sensor Operation Mode.
    LUXEON ON > LUXEON OFF
    [Wave hand in front of the IR Sensor slowly to cycle
    through LUXEON ON and OFF]
    [Press the Operation Button to switch off headlight completely after use]
    *IR does not work with black rubber materials

    Rear Light
    ON > 2Hz FLASHING > OFF

  • Battery Type

    3 x 1.5V AAA Alkaline Batteries [Included]

  • Bulb Type

    1 x Luxeon T White LED
    2 x Ø3mm Nichia White LEDs

  • Size

    Headlight 41mm x 60mm x 35mm
    Battery Pack 72mm x 39mm x 25mm

  • Weight

    117g [With Batteries]

ANSI
HEADLIGHT LUXEON LED HIGH 190 LUMENS 1900cd 87m 8h30min
HEADLIGHT LUXEON LED MED 90 LUMENS 880cd 60m 12h
HEADLIGHT LUXEON LED LOW 20 LUMENS 210cd 29m 125h
HEADLIGHT 3mm LEDs ON 8 LUMENS 30cd 11m 80h
HEADLIGHT 3mms LEDs SOS FLASHING NA NA NA 90h
REAR LIGHT ON NA NA NA 120h
REAR LIGHT 2Hz FLASHING NA NA NA 180h
* Flashing mode specifications cannot be measured by ANSI FL1 standard.
Flashing mode runtime is based on measurement of battery capacity change only.