PHV0C1N001

Li-polymer or 4AA / 1030lm / 2.5h


1030lm Gen-2 Moonbeam Focus Control Headlight, Dual Fuel with Rec. Battery Pack or 4AA Alkaline Batteries


Available in 1 colour
  • LED Focus Control Illumination
  • red rear light
Alkaline or Rechargeable Battery Pack Compatible
  • Rubberized Battery Case
  • free projection angle
  • Luxeon V White LED – Up to 1030 Lumens
  • Adjustable Spot-to-Flood Beam by Twisting Lens Ring
  • Generation 2 Lens projects Uncompromising Spot & Flood Beam
  • 5 Lighting Modes satisfy Different Lighting Needs: White LED – TURBO, HIGH, MED, LOW, 3Hz FLASHING
  • Runs on either Li-polymer Rechargeable Battery Pack [Included] or 4pcs AA Size Alkaline Batteries [Not Included]
  • Direct Plug to Recharge Battery Pack by Micro USB
  • LED Indicator on Recharge Battery Pack shows Charging Status
  • Circuit Protection prevents Battery from Over-charging or Over-discharging
  • Replaceable Rechargeable Battery Pack as Backup Power
  • Rock-solid Protection
  • 2m drop proof
  • IP64 Dust Proof & Water Resistant
  • Operation

    Headlight
    TURBO > HIGH > MED > LOW > 3Hz FLASHING > OFF
    [Press OFF if stays at any mode over 5 seconds]
    [Twist lens ring for LED FOCUS CONTROL]

    Rear Light
    ON > 2Hz FLASHING > OFF

  • Battery Type

    1 x 3.8V 2850mAh Li-polymer Rechargeable Battery Pack [Included] or 4 x 1.5V AA Alkaline Batteries [Not Included]

  • Charging Info

    3.5hrs Charging Time [DC5V 1000mA Input]
    Red LED ON – Charging
    Green LED ON – Fully Charged

  • Battery Cycle

    500 cycles (Reserves ~70% Capacity after 500 cycles)

  • Bulb Type

    1 x Luxeon V White LED

  • Accessory

    Micro USB Cable [Included]

  • Size

    Headlight 61mm x 70mm x 63mm
    Battery Case 79mm x 76mm x 40mm

  • Weight

    292g [With Rechargeable Battery Pack]

ANSI
BOOST 1030 Lumens 14640cd 240m 2h30min
HIGH 540 Lumens 7250cd 170m 6h
MED 260 Lumens 3600cd 120m 9h30min
LOW 50 Lumens 700cd 50m 42h
3Hz FLASHING* NA NA NA 15h
RED ON NA NA NA 90h
RED 2Hz FLASHING* NA NA NA 285h
* Flashing mode specifications cannot be measured by ANSI FL1 standard.
Flashing mode runtime is based on measurement of battery capacity change only.