New lineup

Handheld

Headlight

Lantern

Industrial Light

Bike Light

PH0CM1N014

Li-Polymer / 680lm / 3h

680lm Ultra-wide Curved COB LED for Industrial or Close Range Tasks Dual Fuel with Rec. Battery Pack or 3AA Alkaline Batteries

Available in 1 colour
  • Ultra-wide Lighting
  • Free Projection Angle
  • Red Rear Light
  • Removed Front Cover
Features -
Specifications +
ANSI +
  • Ultra-wide and Curved COB LED Strip Delivers Ultra-wide Lighting - Ideal for Close Range Tasks
  • COB LED – Up to 680 Lumens
  • 4 Lighting Modes – HIGH, MED, LOW, 3Hz FLASHING
  • Runs on either Li-Polymer Rechargeable Battery Pack [Included] or 3pcs AA Size Alkaline Batteries [Not Included]
  • Direct Plug to Recharge Battery Pack by USB-C
  • LED Indicator on Recharge Battery Pack shows Charging Status
  • Circuit Protection prevents Battery from Over-charging or Over-discharging
  • Replaceable Rechargeable Battery Pack as Backup Power
  • Red Rear Light on Battery Case for Safety Indication
  • Free Projection Angle
  • Rock-solid Protection
  • 2m Drop-proof
  • IP66 Dust Proof & High Pressure Water Resistant
  • Operation

    • Headlight
    HIGH > MED > LOW > OFF
    [Long Press for 3Hz FLASHING]
    [Press OFF if stays at any mode over 5 seconds]
    Rear Light
    RED ON > RED 2Hz FLASHING > OFF

  • Battery Type

    • 1 x 3.8V 2000mAh Li-Polymer Rechargeable Battery Pack1
    [Included] Or 3 x 1.5V AA Alkaline Batteries [Not Included]

  • Charging Info

    • 2.5-3 hrs Charging Time [DC5V 1000mA Input]
    RED LED ON – Charging
    GREEN LED ON – Fully Charged

  • Battery Cycle

    • 500 Cycles (Reserve ~70% Capacity after 500 cycles)

  • Bulb Type

    • 1 x White COB LED Strip

  • Accessory

    • 1 x USB-C Cable [Included]

  • Size

    • Headlight 124mm x 36mm x 35mm
    Rear Light 75mm x 62mm x 37mm

  • Weight

    • 192g [With Batteries]

ANSI
HIGH 680 lumens 300cd 35m 3h
MED 350 lumens 150cd 25m 6h
LOW 55 lumens 30cd 11m 12h
3Hz FLASHING NA NA NA 8h
REAR LIGHT RED NA NA NA 116h
* Flashing mode specifications cannot be measured by ANSI FL1 standard.
Flashing mode runtime is based on measurement of battery capacity change only.

You may also like