PL0FW1N002

Li Polymer or 3D / 630lm / 11.5h


630lm Retro LED Filament Lantern, With Rechargeable Battery or 3D Alkaline Batteries


Available in 1 colour
  • BUILT-IN METAL HANDLE
  • BUILT-IN RECESSED HOOK AT LANTERN BASE
  • REMOVABLE CAP
  • RECHARGEABLE BATTERY PACK
  •  Retro Oil Lamp Design with LED Filament Bulb – Up to 630 Lumens
  •  Dial Switch Dimming Control [LOW - HIGH Brightness]
  •  LED Indicator Flashes to Show Lowest/ Highest Brightness Level has been Reached
  •  Runs on Either Rechargeable Battery Pack [Included] or 3xD Alkaline Batteries [Not Included]
  •  Direct Plug to Recharge Battery Pack by Micro-USB
  •  Imitating Candle Light Flickering Mode
  •  Removable Cap allows Direct Illumination
  •  Built-in Recessed Hook at Lantern Base for Hanging as Downlight
  •  IP64 Dust Proof & Water Resistant
  • Operation
  • [Press the Operation Button to cycle through various
    lighting modes]
    ON > CANDLE LIGHT > OFF
    [Twist the Operation Button to adjust brightness level
    at ON mode (except candle light mode).
    Red Indicator flashes twice when reaching lowest
    level; Green Indicator flashes twice when reaching
    highest level]
    [Press OFF if stays at any mode over 5 seconds]

  • Battery Type
  • 1 x 3.7V 4000mAh Li Polymer Rechargeable Battery
    [Included] or 3 x 1.5V D Alkaline Batteries [Not Included]

  • Charging Info
  • 4.5 – 5.5hrs Charging Time
    Red LED ON – Charging
    Green LED ON – Fully Charged

  • Battery Cycle
  • 300 Cycles [Reserves ~ 80% Capacity after 300 cycles]

  • Bulb Type
  • 1 x Replacement LED Filament Bulb (DC 3V)
    [RX0001, Replacement Bulb customized by Favour Light.
    Never use it on household lighting with AC voltage
    or over DC 3V voltage]

  • Accessory
  • 1 x HH01BK Hanging Hook [Included]
    1 x Micro-USB cable [Included]

  • Size
  • Ø112mm x 202mm

  • Weight
  • 785g [With Batteries]

ANSI
HIGH 630 Lumens 95cd 19m 11h30min
LOW 40 Lumens 6cd 5m 148h
CANDLE LIGHT 40 Lumens NA NA 200h
* Flashing mode specifications cannot be measured by ANSI FL1 standard.
Flashing mode runtime is based on measurement of battery capacity change only.